Radiator Replacement (1/29-1/23)

Highlight of this week was probably the removal of a radiator out of NWFD's '87 Chevy suburban. It's a back up rig, very rarely used so it sits unused for long periods of time. While conducting its annual inspection and maintenance, my supervisor and I noticed a great deal of coolant on the front of the engine block. We concluded that the radiator had finally gone south on the ol' girl and needed replacing. Due to a new exhaust system going in at one of the other stations in the district, I was left unsupervised in the shop to complete the tune up and radiator replacement on the suburban. Fortunately, the shop is still standing. I learned the basics about removing and then re-installing a radiator, it was a lot easier than I expected it to be.

Old radiator

 I also replaced the inner tie rod, adjusting sleeve and outer tie rod. This required me to learn how to properly adjust this entire assembly. After many failed attempts and test drives, I finaly managed to get it right.

Hours: 20

Total: 56

Assignment #2 - Breaking the Bucket of Bolts

  We were given four types of bolts, and instructed to break them. Me and my classmate torqued each bolt and recorded the strain on the bolts in pounds when the bolt was torqued to its specified torque. We then continued past the set torque to find how much the bolt could take before breaking, and recorded the max torque and tensile strength in pounds. This assignment gave me valuable knowledge, not only that different grades of bolts and their different strengths, but also, what it feels like when you've gone to far and broken a bolt. We also placed the bolts in a "bolt stretcher" for lack of a better description. It would display the amount of stretch in pounds that were acting on the bolt.

Specs for types of bolts

The Grade 5 actually stripped the threads instead of snapping

3907 bolt

Grade 8

All three after the carnage

Preventative Maintenance and Small Engines (1/12-1/16)

     This last week I have had a wide variety of experience at the shop. For starters, we had an engine come in that was due for it's annual maintenance. This service ensures the proper function of each component; from the apparatus pump system performance to the functionality of a seat buckle, nothing is overlooked. This particular PM that was completed also included a coolant flush. The radiator was first drained into a holding tank, flushed with clean water, then refilled with the appropriate amount of antifreeze.

   I was given the task of performing the annual maintenance of the lawn tools used at on of the staffed stations. I now had a weed eater, leaf blower, and lawn mower placed in my charge. The weed eater and lawn mower were simple enough. I replaced the spark plug, drained the old full mixture, cleaned the air filter, sharpened the blade on the lawn mower, and re-wrapped the string that was put in backwards on the weed eater.

  The leaf blower needed the pull cord replaced, and after struggling with a spring that just did not want to stay put, I managed to get it all back together. Of course, I did loose a VERY small washer which just so happened to be VERY important the the workings of the pull cord assembly. Needless to say, from now on, a magnetic tray will be used when dealing with small components.

Shop Hours: 16
BTC Hours: 14

Day 1 - Bucket of Bolts

Yesterday, my classmate and I worked diligently to complete an assignment given to us by our instructor, Jeff Curtis. The assignment was to identify 4 bags of miscellaneous nuts, bolts, studs, screws, etc. We were to give a brief description of each piece in addition to its size, thread pitch, material, finish, and wrench size. With this information we were to find a part number which would be used to reorder the piece through McMaster - Carr's website.

This exercise familiarized us with a wide range of fasteners and gave us the knowledge and tools to identify them.

Class time 0800-1415
01/12/2015