Monday, August 31, 2015

Week 8 (8/24-8/28)

Last week one of our lifts was having issues with its headlights. This particular lift is used by the airplane mechanics to work on the planes at the airport. They said it was an on going problem of the headlights getting dimmer and dimmer. After hooking up a multimeter I found that the was a voltage drop of about four volts on the passenger side. I traced the wire back to find some "custom" wiring where an aftermarket connection that was made and had come loose and became corroded. After replacing this chunk of wire, both headlights were working at full capacity. I checked the driver side wiring just in case to confirm that no other "custom" wiring jobs would be an issue later down the road.

Unfortunately, I forgot to get the pictures from my co worker but will get those by tomorrow to post here to show. 

Hours last week: 32
Running total: 237.25

Tuesday, August 25, 2015

Week 7 (8/17-21)

Was lucky and got my hands on a starter that we didn't have to turn in for a core. So, I set out to take it completely apart! Here are some pictures of my endeavor.

*The photos posted out of order and my phone would not let me tag each photo. 


Hours: 40
Running total: 205.25
Starter motor out of a generator for one of our De-Icer trucks


Tuesday, August 18, 2015

Week 6 8/10-14

Not much to report on last week. More pictures of bad fuel in rigs. This is the result of poor fuel sources and possibly bigger problems at our fuel farm at the airport. The drip pan you see is JUST diesel from two fuel filters on a belt loader at the airport. Pretty nasty, eh? Test your fuels and record your PM's for the next crew to avoid this contamination.

Document document document.

Hours: 30

Running total:185.25

Monday, August 10, 2015

Week 5 (8/3-7)


This last week at the airport we conducted a series of fuel tests for our fueling trucks. The kit we used had small white test disks with a very fine membrane to them, these were placed in a container that had ports on either side to allow the fuel to travel through them and saturate the disk. A total of one gallon must be passed through the test disk on the inlet and outlet side of the pump. These samples were then compared to a chart to show the quality of the fuel in addition to detecting any water in the system or bacteria growth. However, as the trucks were due for new filters I was able to see first hand the potential damage that bacteria growth can do to a system. The first step to draining the housing that contained the filters is to check for any water build up in the bottom of the housing by simply cracking the valve for a few seconds and then shutting it off to inspect the quality of the fuel. After this, the fuel must be completely drained from the housing so that we we could remove the filters. This was no easy task, because of regulations at the airport we could not bring the fuel trucks to our shop on the other end of the airport. Instead we had to drain them on the designated concrete slab where they are stored in between re-fueling aircraft. One of the trucks so happened to be contaminated and required cleaning of the system as well as treating the tank with a Microbicide. 


Product used 



Test disks contained in these 
Fuel after passing through test
Full set up, inlet is closest to me and outlet is farther away
Fuel filter housing, 
Cleaning out the housing with lint free rags
Beautiful life forms found
Bacteria!! 


Hours this week: 30
Running total: 155.25